The two most important things you can do to your swimming pool is perfect for him full and round. The use of a laser-type for all on your land to prepare and down the footplates. Use a tape measure from a central point to the pool round.

You must first delete entire pool vegetation. Plan at least one to two feet around the pool. If you have a 18 “clearly a round pool area, is of 22 rounds.

The field déboisée must now completely flat. It is recommended that the areas with high dug on the lower level. However, it is not always possible. If you to the areas with low make sure that this area is well packed. Not sand, sand, in order to pave the ground.

If the area, and the good level of the lower rails that could be associated in the footplates to a perfect circle. The next step is the most important for your time. Imagine for each foot plate in exactly the same number on your floor. If you make an appointment on the blocks and blocks of the summit should be all the same number.

If the level footplates are back and pave the ground between the various panels. The lower rails must be based on a solid foundation on the property. The highlights in the lower rails could be cracked on a slope.

Take a little more time on this point, and make sure that the entire area in the lower-level rails and is smooth. For stains or weaknesses can cause, no matter where the coating to meet unequal causes wrinkles. If you have the basis of the sand should be stacked in the middle of the swimming pool at the moment.

Now install the flank. It is better to the installation of the wall in about five times on the rails. You can then the construction of the pool that the wall. This allows the pool wall. Once this step is the pool should be completely together, except for the feed.

If everything is right, and the pool sounds good, you can prepare the database. If you sand to spread and smooth. If the base is to take it out of the pool. The rest of the meeting may be on the outside of the pool.

Before the coating is installed, make sure that no corners on the combination of high ceiling. The tape can be applied to all sharp edges to ensure that they do not rip feed. You can now open the feed introduced and extended. Several people should be used to collect and place them in the pool, kept at the two ends.

Now pull the line and at the top of the rails. Continue to work to the pool around a little bit more each time. If the soil is in some customs bottom rail is very smooth and barely touching sand in the center. It is now time, the water fills.

As the water slowly fills let the tension, as it is. If the water is about two to three inches from the edge cut the hose discount. You can now work to the pool around by a little discount on rails again. Drag the forward line on the wall to install and adjust and the stabilizing rods. Install the rails stand out above and a little more. To do this until it all, and begin to fill the pool.

If the water is just below the opening Skimmer install filters and all accessories. If the pool is full of filter start and check the system to detect leaks. If everything seems in good jump, and amuse you.